MOS 5201 Safety Engineering Unit 5 Essay 1

Course Textbook APA Citation:

Looking for answers to this paper or similar paper?

Classwork Helper will give you the most accurate answers to this question and many more.

High Quality Work Guaranteed!

Order Custom Paper Now

Asfahl, C. R., Hammer, W., & Price, D. (2004/2001). Occupational & industrial safety health management and engineering(2nd Custom ed.). New York, NY: Prentice-Hall.

 

Chapter 8 comes from an OSHA publication on job hazard analysis.

 

 

MOS 5201 uses a custom textbook including only information used in this course, resulting in a more cost-effective textbook than typically available otherwise.

 

Essay #1

 

For each of the following situations, explain the nature of the hazard and describe probable outcomes.

a. A worker brushes his pant leg across a 120-volt terminal strip with screw terminals exposed. Every other screw is hot, with neutral screws intervening.

b. A worker’s boot contacts a 440-volt bus bar. A ground path occurs through the worker’s foot and the nails in the sole of the boot to the concrete floor. The resistance of the ground path is 10,000 ohms.

c. A worker wires a 220-volt circuit “hot” using a wood-handle screwdriver. The screwdriver slips, and the shaft of the screwdriver makes a direct short across the hot terminal and the adjacent neutral.

d. A worker changes a 120-volt wall receptacle in a garage while standing on a concrete floor. The circuit is energized, but the worker is careful not to touch both the hot wire and the neutral wire at the same time.